Operating Procedures For Deep Well Pumps

Aug 20, 2024

Deep well pump is a device used to pump groundwater to the surface, widely used in fields such as agricultural irrigation, industrial water use, urban water supply, etc. Proper operation of a deep well pump can ensure its efficient and stable operation. The following will introduce the operating process of using a deep well pump.
1, Safety preparation
Before using a deep well pump, safety preparations need to be made to ensure the safety of the operation.
1. Wear personal protective equipment such as safety helmets, protective shoes, etc. At the same time, ensure that there are no physical disabilities to prevent accidents during the operation.
2. Check the working condition of the deep well pump and related equipment to ensure that they are intact and undamaged. Special attention should be paid to whether there are water leaks, looseness, and other issues in the pump body, valves, electrical equipment, and other parts.
3. Confirm the power supply situation and ensure that the power supply voltage and frequency meet the requirements of the deep well pump. At the same time, check if the cable connections are secure to avoid danger caused by loose cables.
2, Start the deep well pump
After completing the safety preparation, the deep well pump can be started by following the steps below:
1. Open the inlet valve to fill the pump with water and ensure that there is no air leakage in the suction pipe and inlet valve of the pump.
2. Place the control switch in the "stop" position, and then turn on the power switch.
3. Press the control switches in the order of starting the deep well pump, such as the manual start switch, automatic start switch, etc.
4. Observe the working status of the deep well pump and confirm whether it is operating normally. Meanwhile, pay attention to checking whether the parameters such as current and voltage are within the normal range.
3, Operate deep well pump
After the deep well pump operates normally, it needs to be operated according to actual needs.
1. Adjust the outflow rate: By adjusting the opening of the outflow valve, the outflow rate of the deep well pump can be controlled. Adjust valves as needed to meet irrigation or water supply requirements.
2. Monitoring the operating parameters of deep well pumps: The operating parameters of deep well pumps, such as current, voltage, pressure, etc., should be regularly checked and compared with normal values to ensure the normal operation of the equipment.
3. Regular maintenance: Deep well pumps may experience some malfunctions or wear after long-term operation. Therefore, regular maintenance is crucial for the long-term use of equipment. This includes tasks such as cleaning, lubrication, and fastening parts.
4, Stop the deep well pump
When the deep well pump is no longer needed, it is necessary to stop its operation correctly to protect the equipment and extend its service life.
1. Turn off the power switch, start switch, and other control switches, and place them in the "stop" position.
2. Close the outlet valve and stop the water supply to the deep well pump.
3. Wait for the deep well pump to completely stop running before cutting off the power supply.